Sony KD-32DX40U TV Receiver User Manual


 
Advanced Operation
Advanced Operation
23
5. Highlight and activate one of the options using the v and b buttons, then press the v or V buttons to
set the option to On or Off. See the table below for an explanation of each option and their effects.
6. Press the OK button to store the new setting, then repeat step 5 to alter the other options.
7. Press MENU button to return to normal TV operation.
Dolby* Virtual When set to On, the TV simulates the effects of Dolby Pro Logic Surround sound.
Note: If you connect headphones to this TV or if you set the Auto Volume option to On,
Dolby Virtual will automatically be set to Off.
Auto Volume When set to On, the volume level will remain constant even if the broadcast level
should change, i.e. during commercial breaks.
Note: This option automatically sets itself to Off when Dolby Virtual is set to On.
TV Speakers Set to Off if you wish to connect an external amplifier to the audio output sockets on
the rear of the TV.
Notes on the Sound Adjustment menu
Highlight Reset and press OK only if you wish to return the sound settings to their factory preset levels.
When receiving a bilingual broadcast set the Dual Sound option to A for channel 1 sound, B for channel 2 sound or Mono if the mono
channel is available for selection. When receiving a stereo broadcast the Dual Sound option can be set to Stereo or Mono.
* This TV has been designed to create a Virtual Dolby Surround sound effect from a Dolby Pro Logic Surround broadcast without the need for
additional speakers. However, you can connect an external amplifier to this TV if desired (see Connecting additional equipment section of
this manual).
* Manufactured under licence from Dolby Laboratories. Dolby, Pro Logic and the double-D symbol are trademarks of Dolby Laboratories.
The Timer menu
The Sleep Timer allows you to select a period of time after which the TV automatically switches itself
into standby mode.
1. Press the MENU button to display the main menu. Use the v or V button to highlight the symbol.
Press the b button twice to highlight Off in the SleepTimer menu.
2. Press the v or V buttons to set the amount of time before the TV switches itself into standby. This
can be in 15 minute intervals up to a maximum of 4 hours.
3. Press the OK button to store.
4. Press the MENU button to return to normal TV operation. One minute before the TV switches into
standby, the time remaining is counted down on screen.
Note: In analogue mode you can check the time remaining until standby by pressing the button. The time
remaining is displayed in the bottom left corner of the TV screen.
O
K
DX40 Pages 21-30.fm Page 23 Wednesday, August 22, 2001 12:09 PM