Filter
Top Products
117
Other InfoOther Info
General
Problem Possible Remedies
How to reset TV to factory
settings
s Turn on the TV. While holding down the RESET button on the remote control,
press the POWER button on the right side of the TV. (The TV will turn itself off,
then back on again.) Release the RESET button.
How to restore Video settings to
factory settings
s Press the RESET button on the remote control while in the Video Menu (see page
92).
How to restore Audio settings to
factory settings
s Press the RESET button on the remote control while in the Audio Menu (see page
95).
Cannot cycle through the other
video equipment connected to
the TV
s Be sure the Label Video Inputs option is not set to Skip (see page 105).
Cannot operate Menu s If a Menu option appears in gray, this indicates that the TV is in a state in which
the Menu option is not available.
Lost password s In the password screen (see page 101), enter the following master password: 4357.
The master password clears your previous password; it cannot be used to
temporarily unblock channels.
TIMER LED on front panel is lit s The LED (see page 16) blinks when the TV is turned on, then shuts off when the
picture is displayed. If the LED blinks continuously, this may indicate the TV
needs service. When lit, indicates that the timer is set (page 107). When the timer
is set, this LED will remain lit even when the TV is turned off.
Digital cable box does not work s If you are connecting a VCR and digital cable box using a splitter, as described on
page 32, you must use a special bi-directional splitter that is designed to work with
your digital cable box. Contact your cable TV company for details.
Cannot record digital channels
to VCR
s Only analog channels can be recorded to your VCR.