Filter
Top Products
10 (GB)
4 RGB1 OUT connectors
These connectors are used as loop-through outputs of
the RGB1 IN connectors 1.
When the plug is connected to the RGB OUT
connectors, the 75-ohms termination of the RGB IN
connectors is released, and the signal input to the
RGB IN connectors is output from the these
connectors.
R (R-Y)/G (Y)/B (B-Y) OUT (BNC-type): Loop-
through outputs of the RGB IN connectors.
Connects to the RGB signal or component (Y/B-
Y/R-Y) signal input of another monitor.
HD/COMP OUT (BNC-type): Loop-through output
of the HD/COMP IN connector. Connects to the
H sync signal or composite sync signal input of
another monitor.
VD OUT (BNC-type): Loop-through output of the
VD IN connector. Connects to the V sync signal
input of another monitor.
Note
The HD/COMP OUT and VD OUT connectors are
high impedance outputs.
When using these outputs, connect a monitor with a
high impedance sync input connector, or the picture
might oscillate or disappear because of the sync
signal level mismatch.
AUDIO OUT (L/R) (phono type): Loop-through
outputs of the AUDIO IN jacks. Connects to the
audio inputs of another monitor.
5 LINE OUT connectors
These connectors are used as loop-through outputs of
the LINE IN connectors 3.
When the plug is connected to the VIDEO OUT
connector or Y/C OUT jack, the 75-ohms termination
of the VIDEO IN connector or Y/C IN jack is
released, and the signal input to the VIDEO IN or Y/C
IN jack is output from the VIDEO OUT connector or
Y/C OUT jack.
VIDEO OUT (BNC-type): Connects to the
composite video signal input of another monitor
or video equipment.
Y/C OUT (Mini DIN 4-pin): Connects to the Y/C
signal input of another monitor or a piece of
video equipment.
AUDIO OUT (L/R) (phono type): Loop-through
outputs of the AUDIO IN jacks. Connects to the
audio inputs of another monitor or a piece of
video equipment.
Location and Function of Parts and Controls
6 REMOTE (RS-232C) connector (mini DIN 8-
pin)
This connector allows remote control of the monitor
using the RS-232C protocol. For details, contact your
authorized Sony dealer.
Left Connector Panel
1 MONITOR OUT AUDIO (L/R) jacks (phono
type)
Outputs the signal input from the AUDIO IN jacks.
Connects to the audio inputs of an audio amplifier
(not supplied).
Note
These jacks are variable outputs. Set the volume to the
maximum position to set the output level to
500 mVrms.
MONITOR OUT
CONTROL S
SPEAKERS
(6-16 Ω)
AC IN
SERVICE CODE
AUDIO
RL
IN
+
R–
+
L
–
OUT
VARIABLE
5
4
3
2
1
8.8.