Filter
Top Products
34 (GB)
Controlling Power On/Off
Automatically (Power
Control Function)
This monitor has two power controlling functions.
You can set it to turn off the power automatically after
a certain period if there is no input signal from the
RGB1 or RGB2 connectors (POWER SAVING
function). You can set the time when the power
automatically turns on/off (ON/OFF TIMER
function).
Power Saving Function
1 Press MENU.
The main menu appears on the monitor screen.
ENTER
MENU
MA IN MENU
PIC CONTROL
PIC SIZE
CONF IG
MEMORY
REMOTE
STATUS
SELECT SET END
2 Press M/m to move the cursor (B) to “CONFIG”
and press ENT.
The CONFIG menu appears on the monitor
screen.
ENTER
MENU
CONF IG
DISPLAY : ON
CLOSED CAPTION: OFF
COLOR SYSTEM : AUTO
SCREEN F ILL :CENTER
POWER CONTROL
SCREEN SAVER
TIME SET
LANGUAGE
SELECT SET END
Controlling Power On/Off Automatically (Power Control Function)
3 Press M/m to move the cursor (B) to “POWER
CONTROL” and press ENT.
The following menu appears on the monitor
screen.
ENTER
MENU
POWER CONTROL
POWER SAV ING : OFF
ON/OFF T IMER : OFF
SELECT SET END
4 Press M/m to move the cursor (B) to “POWER
SAVING” and press ENT.
The following menu appears on the monitor
screen.
POWER SAV ING : OFF
5 Press M/m to select the length of the time until the
change to power saving mode.
OFF: The power saving function does not work.
5min: Change to the power saving mode after
five minutes if there is no input signal.
10min: Change to the power saving mode after
10 minutes if there is no input signal.
The power indicator flashes when the unit is in the
power saving mode.
To cancel the power saving function
• Input the sync signal again.
• Press the 1 switch on the control panel or the
POWER switch on the Remote Commander.
Signal specification for using the power
saving function
RGB1: When the sync signal is connected to the
HD/COMP IN connector.
RGB2: When the sync signal is connected to the
13th pin of the RGB IN (D-sub 15-pin)
connector.