Sony PFM-500A3WU Flat Panel Television User Manual


 
18 (GB)
ql COLOR SYSTEM
Selects the input signal.
AUTO: to display NTSC, PAL or SECAM signals
443NT: to display NTSC4.43 signals
PAL60: to display PAL60 signals
w; SCREEN FILL
Selects the point of origin for resizing the picture.
CENTER: Sets the point of origin on the center of
the monitor.
CORNER: Sets the point of origin at the upper-left
corner of the monitor.
wa POWER CONTROL
Sets the length of time until the system goes into the
power saving mode.
For details, see “Controlling Power On/Off Automatically
(Power Control Function)” on page 34 (GB).
ws SCREEN SAVER
Enables the screen saver to reduce afterimage or
ghosting.
For details, see “Reducing Afterimage/Ghosting (Screen
Saver Function)” on page 31 (GB).
wd TIME SET
Sets the time.
For details, see “Adjusting the time” on page 21 (GB).
wf LANGUAGE
Selects the on-screen language (English, German,
French, Italian, Spanish or Japanese).
For details, see “Selecting the On-screen Language” on
page 31 (GB).
MEMORY menu
This menu is used for saving or recalling the settings
in the PIC CONTROL and PIC SIZE menus.
ENTER
MENU
MEMORY
LOAD
SAVE
wh
wg
SELECT SET END
For details, see “Using the Memory Function” on page 29
(GB).
wg LOAD
Recalls the preset settings.
wh SAVE
Saves the settings.
REMOTE menu
This menu is used for remote control settings.
ENTER
MENU
REMOTE
INDEX No. : 001
REMOTE MODE : TV
REMOTE ONLY : OFF
wk
wj
wl
SELECT SET END
wj INDEX No.
Sets the index number of the monitor.
Note
When you set the number, use the buttons on the
monitor.
For details about the index number, see “Operating a
Specific Monitor With the Remote Commander” on page 36
(GB).
wk REMOTE MODE
Selects the Remote Commander mode.
TV: The Sony monitors’ or the TVs’ commander
PJ: The Sony projectors’ commander
OFF: Disables the remote control.
Note
When you change the Remote Commander mode, use
the buttons on the monitor. You cannot change the
Remote Commander mode with the Remote
Commander.
For details, see “Using Other Remote Commander
Models” on page 38 (GB).
wl REMOTE ONLY
Select ON to disable the front control buttons on the
monitor. The monitor can only be controlled with the
Remote Commander. While REMOTE ONLY is ON,
the indicators on the front panel go off.
To cancel the REMOTE ONLY mode, set REMOTE
ONLY to OFF with the Remote Commander, or press
the CTRL button while pressing the 1 switch on the
monitor. The monitor turns to the standby mode and
the REMOTE ONLY mode is cancelled.
The setting in this item is still retained when the AC
power cord is disconnected or when you turn on/off
the monitor with the Remote Commander.
Using On-screen Menus