Filter
Top Products
16 (GB)
Using On-screen Menus
Using On-screen Menus
Operating Through Menus
Menu operating buttons
There are four buttons on the monitor and the Remote
Commander for menu operations.
SELECT
MENU
ENTER
MENU ENT
m
M
The buttons on the control panel are used for
explanation purposes in this operating instructions.
The ENTER button on the Remote Commander has
the same function as the ENT button on the control
panel and the SELECT +M/–m buttons on the Remote
Commander as same as the M/m buttons on the
control panel.
Configuration of the menu
To select the language used in the menu, see page
31 (GB).
1 Press MENU.
The main menu appears on the monitor screen.
ENTER
MENU
MA IN MENU
PIC CONTROL
PIC SIZE
CONF IG
MEMORY
REMOTE
STATUS
SELECT SET END
2 Press M/m to move the cursor (B) and press ENT
to select a menu.
The selected menu appears on the monitor screen.
3 Press M/m to move the cursor (B) and press ENT
to select an item.
The menu for the selected item appears on the
monitor screen.
4 Press M/m to adjust or select the setting and press
ENT to set.
The setting is registered and the menu returns to
the previous menu.
To return to the normal screen, press the MENU
button repeatedly until the menu disappears.
Menu Guide
Note
“– – – –” appears next to an item when its function is
not available. The availability depends on the types of
input signal.
PIC CONTROL menu
This menu is used for adjusting the picture.
ENTER
MENU
PIC CONTROL
CONTRAST : 80
BRIGHTNESS : 00
CHROMA : 00
PHASE : 00
PICTURE AGC : ON
COLOR TEMP : HIGH
SHARPNESS : MID
4
3
2
1
5
6
7
8
RESET
SELECT SET END
1 CONTRAST
Press M to increase the contrast and press m to
decrease it.
2 BRIGHTNESS
Press M to make the picture brighter and press m to
make it darker.
3 CHROMA
Press M to increase color saturation and press m to
decrease it.
4 PHASE
Press M to make the overall picture greenish and press
m to make it purplish.
5 PICTURE AGC
Select ON to automatically increase the brightness
when a low brightness signal is input.
This function works only for LINE input or 15 kHz
YUV input.
Remote Commander Control Panel