Filter
Top Products
73
Additional Information
, The remote is not pointed at the remote sensor on
the recorder.
, Different command modes are set for the
recorder and remote. Set the same command
mode (page 17). The default command mode
setting for this recorder and the supplied remote
is “3 (Default setting).” You can check the
current command mode in the front panel display
(page 17).
Other Sony equipment responds to the remote.
, The same command mode is set for both the
equipment and recorder. Set a different
command mode for the recorder (page 17).
The recorder does not detect USB memory
connected to the recorder.
, Make sure that the USB memory is securely
connected to the recorder (page 24).
, Check that the USB memory is not damaged.
The recorder does not operate properly.
, Restart the recorder. Press down "/1 on the
recorder for more than five seconds until the
recorder turns off. If a disc is still in the recorder,
press Z OPEN/CLOSE and remove the disc.
, When static electricity, etc., causes the recorder
to operate abnormally, turn off the recorder and
wait until the clock appears in the front panel
display. Then, unplug the recorder and after
leaving it off for a while, plug it in again.
The disc tray does not open after you press Z
OPEN/CLOSE.
, It may take a few seconds for the disc tray to
open after you have recorded or edited a DVD.
This is because the recorder is adding disc data to
the disc.
Others