Filter
Top Products
D:\DVD
manual\Final\218839311_FM\01GB04BAS.fm
master page=right
RDR-GXD500
2-188-393-11(1)
17
Hookups and Settings
Step 4: Connecting the Audio Cords
Select one of the following patterns A or B, according to the input jack on your TV monitor, projector,
or AV amplifier (receiver).
This will enable you to listen to sound.
z Hint
For correct speaker location, see the operating instructions supplied with the connected components.
Note
Do not connect your TV’s audio output jacks to the LINE IN (AUDIO L/R) jacks at the same time. This will cause
unwanted noise to come from your TV’s speakers.
VIDEO
AUDIO
INPUT
L
R
AERIAL
IN
LINE 4 IN DIGITAL OUT
COAXIAL
OPTICAL
PCM/DTS/MPEG/
DOLBY DIGITAL
COMPONENT
VIDEO OUT
VIDEO
S VIDEO
AUDI ORL
LINE 2 OUT
VIDEO
S VIDEO
AUDI ORL
Y
P
B
/
C
B
P
R
/
C
R
~ AC IN
OUT
LINE 1 - TV LINE 3
B
A
DIGITAL OUT
COAXIAL
OPTICAL
PCM/DTS/MPEG/
DOLBY DIGITAL
LINE 2 OUT
VIDEO
S VIDEO
AUDIORL
AV amplifier (receiver)
with a decoder
(red)
TV, projector, or AV
amplifier (receiver)
Audio/video
cord (supplied)
: Signal flow
Coaxial digital cord
(not supplied)
to DIGITAL OUT (COAXIAL or
OPTICAL)
to LINE 2 OUT (R-AUDIO-L)
Optical digital cord (not supplied)
Rear (L)
DVD recorder
(white)
(yellow)*
(yellow)
(white)
(red)
[Speakers]
Front (L)
[Speakers]
to coaxial
digital input
Rear (R)
Front (R)
Subwoofer
or
Centre
* The yellow plug is used for video signals (page14).
to optical
digital input
,continued
01GB01.book Page 17 Mardi, 7. septembre 2004 9:41 09