Filter
Top Products
23
Operation
Registering the connected components
The following procedure lets you set up the commander
to operate the components connected to the receiver.
When carrying out this operation, make sure that the receiver’s
power is on, and be sure to point the commander’s transmitter/
receiver section toward the display on the receiver.
1 Touch SETUP.
The SETUP screen appears.
2 Touch FUNCTION&USER IR.
The FUNCTION&USER IR screen appears.
3 Select the function that you wish to register (Ex:
VIDEO1).
To display other items, use the JOG DIAL or touch 4
or $ to scroll through the list.
The FUNCTION&USER IR:CATEGORY screen
appears.
4 Select the type of component connected (Ex: VCR).
To display other items, use the JOG DIAL or touch 4
or $ to scroll through the list.
The FUNCTION&USER IR: MAKER CODE screen
appears.
5 Touch the remote controller mode of the connected
component (Ex: Sony VTR1).
The component selected in steps 4 to 5 will be
registered at the function selected in step 3, and the
FUNCTION&USER IR screen reappears. A long beep
sound is emitted to indicate that registration was
successful. Operation is now possible from the
FUNCTION screen.
If a series of short beeps is emitted, redo the
registration procedure. If this occurs, make sure the
receiver is turned on and that the commander is
pointing toward the receiver during operation.
To stop registration at any time
Touch EXIT during step 3 or touch CANCEL during steps 4 to 5.
Notes
• All icons may not be displayed when registering components
made by certain manufacturers.
• Some commands may not function even though they are
displayed when registering components made by certain
manufacturers.