Filter
Top Products
27
Operation
4 Touch NAME EDIT.
The NAME EDIT screen appears.
5 Enter the name.
After the name has been entered, touch SET. The new
function name is set in the commander.
After the name has been entered, point the
commander toward the receiver and touch UPLOAD.
The new function name is set in the receiver.
Current name display
Name input display
Touch to
upload the
name to the
receiver.
Name input buttons
Setting remote control codes that are not
stored in the commander
When a remote control code is not one of the presets
stored in the commander, it is possible for the commander
to learn the code using the Learning function. For details
on how to use the learned codes, please see page 17.
1 Touch SETUP.
The SETUP screen appears.
2 Touch LEARNING.
3 Touch the area corresponding to where you want
the new code to be learned. Any letter from A to J
can be selected (for example, select “A”).
4 Touch the Box Number where you want to save the
new code (for example, select “A6”).
The LEARNING SETUP screen is displayed.
5 Touch “Learning Start”.
“Please Send Signal” is displayed.
Learning area
Message
window
Code set mark
Box number
assigned for new
code
Command
button
Name input
button
Box number assigned for new code
Touch to set
the name to
the commander.