Filter
Top Products
22
RM-VLZ620_U (US) 4-170-639-12(1)
Note
If the SET indicator flashes only once, it
indicates that learning is incomplete.
Repeat from Step 4 again.
7 Repeat Steps 4 to 6 to teach
other new functions.
8 Press SET to finish teaching.
The SET indicator turns off.
To cancel the process
Press SET anytime.
Notes
If you teach a signal to a button, the
learned function will remain even after
you set a manufacturer’s code.
You cannot teach a simultaneous button
operation (for example + ) to the
two buttons on the RM-VLZ620 at a time.
In this case, teach the signal to a single
button while pressing two buttons on the
original remote control at the same time.
To teach an air-conditioner’s
functions
If you adjust the setting of the air-
conditioner according to the season,
reset the parameters of the air
conditioner’s remote control
(temperature, air strength and
direction, etc.), and teach the new
remote signals to the RM-VLZ620.
When the power button on the
remote control for an air-
conditioner, etc., toggles between
power-on and off with each press,
the power-on/off operation may not
be learned correctly. In this case,
teach the power-on/off signals to
two separate buttons on the
RM-VLZ620.
1 Teach the power-on signal to a
button (transmit the power-on
signal by pressing the power
button when the device is turned
off).
2 Teach the power-off signal to
another button (transmit the
power-off signal by pressing the
power button when the device is
turned on).
The two learned buttons of the RM-
VLZ620 now control the power-on/
off signals of the device respectively.
Note
Devices such as air conditioners and heaters
receiving an infrared signal can be dangerous
if misoperated. Be sure to place the RM-
VLZ620 out of the reach of small children or
pets, and lock the controls using the Hold
function (page 31).
Tips for teaching accurately
Do not move the remote control
units during the learning
procedure.
Use new batteries in both remote
control units.
Avoid performing the learning
procedure in places subject to
direct sunlight, or strong
fluorescent light. (Noise may
interfere with the learning
procedure.)
The remote control detector area
may differ depending on each
remote control unit. If the RM-
VLZ620 does not learn signals, try
changing the positions of the two
remote control units.
When you teach the signals of an
interactive signal exchange system
remote control unit (supplied with
certain Sony’s amplifiers) to the
RM-VLZ620, the response signal
of the main unit may interfere
with the learning of the RM-
VLZ620. In such a case, move to a
place where the signals will not
reach the main unit (e.g., another
room).