Filter
Top Products
20
3-2. Back Panel of the DIRECTV
®
HD Receiver
(1080i/720p/480p)(1080i/720p/480p)
RGB OUT
DATA PORT
DVI-HDTV OUT
SATELLITE
IN
TYPE
CABLE IN
ANT IN
OUT TO TV
Y
COMPONENT OUT
(1080ii/720p/480p/480ii)
Pr
1
L2
R2R1
L1
2
AUDIO OUT
Pb
OPTICAL
DIGITAL
AUDIO
OUT
S VIDEO
OUT
VCR
CONTROL
RF
REMOTE
(1080ii/720p/480p/480ii)
PHONE
JACK
VIDEO OUT
Ant In
Is used to connect an over-the-air or terrestrial antenna.
Cable In
Is used to connect a coaxial cable coming from your cable TV service outlet or cable box.
Out to TV
Provides an RF connection between the DIRECTV HD Receiver and older TVs. All decoded signals are
provided on channel 3 or 4 as selected in the Output Channel section of the Setup menu. When the
DIRECTV HD Receiver is in the standby mode, Cable or Antenna signals are passed through as chosen
in the Out to TV section of the Setup menu.
Video Out 1, 2
Is used to provide baseband composite video signal to a VCR or TV set. Video connection generally
provides picture quality that is superior to RF connections. For a better quality picture connection, use
the S-Video jack if it is available.
Component Out
Is used to connect to a Y/Pb/Pr-compatible monitor. Three video and two audio jacks for a Y/Pb/Pr
monitor need to be connected and the TYPE switch must be set to left position.
RGB/DVI-HDTV Out
Is used to connect to either an RGB compatible or DVI-HDTV monitor. Either an RGB port for an RGB
monitor or a DVI-HDTV port for a DVI-HDTV monitor need to be connected and the TYPE switch must
be set to right position.
Note : The DVI-HDTV port has a higher priority when both the RGB and DVI-HDTV ports are connected.
Note: For best access to High-Definition Programming from DIRECTV, connect the DVI-HDTV output to
a DVI-HDTV input on your high-definition TV or monitor. A DVI-HDTV input is one that is compliant
with EIA-861 and HDCP specifications. Check your TV or monitor’s user manual to find out if the TV or
monitor’s DVI input is compliant with these specifications.