Sony KLV 15SR1 Flat Panel Television User Manual


 
9
Installing and Connecting the TV
75-ohm coaxial
cable (supplied)
Rear of TV
VHF/UHF
Basic Connections
(Connecting Cable TV or
an Antenna)
When connecting an antenna or cables, remove the
rear cover of the TV beforehand.
Removing the rear cover
1 Slide the rear cover upward by approx. 1 cm
(
13
/32 inch) while holding it with both hands as
shown in the diagram below.
2 Pull the rear cover towards you.
Rear of TV
VHF/UHF
IN
OUT
Cable
Cable box
75-ohm coaxial
cable (supplied)
Connecting directly to cable or an
antenna
VHF only or VHF/UHF or cable
Note
It is strongly recommended to connect the antenna using a 75-
ohm coaxial cable to get optimum picture quality. A 300-ohm
twin lead cable can be easily affected by radio noise and the like,
resulting in signal deterioration. If you use a 300-ohm twin lead
cable, keep it away as far as possible from the TV.
Cable box connections
Use this hookup if:
•You subscribe to a cable TV system that uses
scrambled or encoded signals requiring a cable
box to view all channels, and
•You do not intend to hook up any other audio or
video equipment to your TV.
1 Connect the coaxial connector from your cable
service to the cable box’s IN jack.
2 Using the supplied 75-ohm coaxial cable,
connect the cable box’s OUT jack to the TV’s
VHF/UHF jack.
Also, set “Cable” to “On” in the
(Channel)
menu (See page 20).
Tips
Your Sony remote control can be programmed to operate your
cable box (See “Programming the remote control” on page
28).
To change channels using the cable box, set your TV to
channel 3 or 4 depending on the cable box channel output.
If you will be controlling all channel selection through your
cable box, consider using the Channel Fix feature to set your
TV to channel 3 or 4 (See page 21).
Attaching the rear cover
1 Hold the rear cover with both hands, then fit the
four detents on the rear cover into the
corresponding keyholes on the TV while keeping
the rear cover approx. 1 cm (
13
/32 inch) higher
than the TV as shown in the diagram below.
2 Slide the rear cover downward while keeping it
pressed against the TV.