Filter
Top Products
16
Installing and Connecting the TV
Connecting a DVD Player with Component Video
Connectors
This is the preferred hookup to use if:
•Your DVD player has component (Y, B-Y, R-Y) jacks.
Disconnect all power sources before making any connections.
1 Using a component video cable, connect the DVD player’s Y, B-Y and
R-Y jacks to the Y, P
B and PR jacks on the TV. Use the VIDEO 3 IN
connections.
Note
This TV supports only the 480i and 480p signal format. If the TV receives a signal other
than 480i or 480p, “Non Supported Video Format” appears on the screen.
Tip
The Y, B-Y and R-Y jacks on your DVD player are sometimes labeled as Y, CB and CR,
or Y, PB and PR. If so, connect the cables to the matching colors.
2 Using an AUDIO cable, connect the DVD player’s AUDIO OUT jacks to
the TV’s AUDIO IN jacks.
Note
The Y, B-Y and R-Y jacks do not provide audio, so audio cables must be connected to
provide sound.
Tips
• To take advantage of the Wide Screen Modes, set the TV’s aspect ratio to 16:9 on your
DVD player. For details, refer to the operating instructions supplied with your DVD player.
• Some DVD players are equipped with the three component video connectors: Y-Green, P
B
(CB, Cb or B-Y) -Blue and PR (CR, Cr or R-Y) -Red.
Component
video cable
(not supplied)
DVD player
Rear of TV
AUDIO cable
(not supplied)
PR
PB
Y
AUDIO-R
(red)
AUDIO-L
(white)