Filter
Top Products
6
Installing and Connecting the TV
Installing and
Connecting the
TV
Unpacking
When you unpack this unit, make sure it includes the
following:
Operating Instructions
Warranty Card
Product Registration
Inserting Batteries into
the Remote Control
Insert two size AA batteries (supplied) by matching
the + and – on the batteries to the diagram inside the
remote control’s battery compartment.
Notes
• Remove the batteries to avoid damage from possible battery
leakage whenever you anticipate that the remote control will
not be used for an extended period.
• Handle the remote control with care. Avoid dropping it,
getting it wet, or placing it in direct sunlight, near a heater or
where the humidity is high.
• Your remote control can be programmed to operate most video
equipment (See “Operating Video Equipment with Your TV
Remote Control” on page 30).
AC power cord (1)
Connector Types
You may find it necessary to use some of the
following connector types during set up.
Supplied 75-ohm coaxial cable
Screw-on type
S VIDEO cable
High quality video cable for enhanced picture quality
AUDIO/VIDEO cable
VIDEO - Yellow
AUDIO (Left) - White
AUDIO (Right) - Red
Some DVD players are equipped with the following
three video connectors:
Y - Green
P
B (CB, Cb or B-Y) - Blue
P
R (CR, Cr or R-Y) - Red
Screw into connection.
Align guides and push into
connection.
Push into connection.
75-ohm coaxial cable (1)
Remote control (1) and
size AA batteries (2)