Filter
Top Products
Page 12
TV Installation
REAR PANEL CONNECTION DIAGRAMS
CONNECTING TO AN ANTENNA CONTINUED
Connecting to Cable or Antenna through VCR
1. Make sure the power of the TV is turned o.
2. Make sure there is an antenna or cable connection to the VCR already.
3. Use a Coaxial RF cable and connect from your VCR’s Antenna Out or Output to TV to
the ATSC/NTSC port of your TV.
4. Turn on the TV.
5. Select TV (Air) for antenna or TV (Cable) for digital cable from either your remote
control’s source button or source button on the TV.
6. Use the On-Screen Display to scan for channels.
Note:
• Some VCRs must be turned On before its output will have a signal to the TV.
Please consult your VCR manual for further reference.
• Not all broadcasts are in High Denition (HD). Please refer to your local broadcasting stations for more information.
• This model’s tuner is designed for HDTV therefore it requires a stronger signal than normal TVs. If you cannot achieve that
signal level with your antenna or cable, the TV might lose picture or sound.
• This TV will turn o automatically if there’s no signal present for more than 15 minutes.
1. Make sure the power of the TV and your DVD player is
turned o.
2. Connect a HDMI cable to the HDMI port of your DVD
player and the other end to the HDMI port o the back of
your TV.
3. Turn on the TV and your DVD player.
4. Use the remote control’s source button or the source
button on the TV to switch to HDMI.
Note:
• Refer to the DVD player’s manual to make sure the DVD
player is congured to output correctly to the TV.
• This TV does not decode Bit stream digital audio, so
make sure the DVD is setup for PCM digital audio
through HDMI.
• If HDMI 1 is occupied, use HDMI 2 as your connection
port.
1. Make sure the power of TV and your DVD player is turned o.
2. With a Component Cable, connect the green connector to the
DVD player and Component 1’s green connector port on the TV.
3. Connect the blue color connector to your DVD player and
Component 1’s blue connector port on the TV.
4. Connect the red color connector to both your DVD player
and Component 1’s red connector port on the TV.
5. With an RCA Audio Cable, connect the white color connector
to both your DVD player and Component 1’s white connector
port on the TV.
6. Connect the red color connector to both your DVD player
and Component 1’s red connector port on the TV.
7. Turn on the TV and your DVD player. Use the remote control’s
source button or the source button on the TV to switch to YPbPr1.
Note:
• If Component 1 is already occupied, please use
Component 2 as your connection port and switch to
source YPbPr2.
• Refer to the DVD player’s manual to make sure the DVD
player is congured to output correctly to the TV.
• This TV will turn o automatically if there’s no signal
present for more than 15 minutes.
Connecting with HDMI (Best)
Connecting with Component (Better)
CONNECTING TO A DVD PLAYER