Filter
Top Products
Page 8
TV Installation
WARNING: Do not connect the power source before making connections.
REAR PANEL INTERNAL CONNECT SOURCE
Internal Connect Source through the cable access door.
The Internal Connect Source allows you to easily connect to the Audio, Optical, Video, HDMI, and Audio Out. The Internal Connect
Source is inside the Cable Cover located on the back of the unit (Figure 1).
1. Unscrew the two Thumb Screws (Figure 1), and pull the cover towards you.
2. Route the cables to the proper inputs, and place the cable cords over the Rubber Sealing Gasket on the bottom of the cable
access opening(Figure 2).
3. Be sure the cables are routed past the indentation on the bottom of the door. Cable cannot be routed through the top and
side of the rubber sealing gasket. (Figure 3).
4. Close the cover.
5. Press rmly on the cover, and screw the Thumb Screws tightly (Figure 4).
Figure 1
Figure 2
Figure 4
Rubber Sealing Gasket
Thumb Screws
CONNECTING THE POWER CORD
Do not connect power cord until all cable connections have been made.
Connect the power cord to a GFCI protected AC outlet with an “in-use” waterproof cover.
WARNING:
TV AND GFCI RECEPTACLE MUST BE INSTALLED AT LEAST 5 FEET AWAY FROM STANDING WATER , SUCH AS (BUT NOT
LIMITED TO) A POOL OR SPA. BE SURE TO CHECK LOCAL ELECTRICAL CODES AND COMPLY WITH THEIR LOCAL STANDARDS.
Route cables trough the
bottom of the door only
Figure 3