Filter
Top Products
TANDBERG Videoconferencing System
19
Installation
System configuration
• Switch the system on by connecting the power cable to an electrical distribution socket.
• After the system has performed a self-test routine, product logo and a ‘Welcome’ menu will be displayed on the
monitor.
connect
menu
• Enabled but unused ISDN lines (lines not active) should be disabled. Select the Quick Key ‘System Info’ (on
the remote control) to view line status.
PRESS MENU ON THE REMOTE CONTROL. SELECT THE MENU ‘TERMINAL SETTINGS’, ‘NETWORK’, ‘ISDN-BRI SETTINGS’. SELECT THE
RELEVANT ‘LINE SETUP’ MENU AND SET ‘ENABLED: OFF’.
• Enter System Name to identify the system during an MCU conference. Select ‘Utilities’, ‘System Name’ and
enter the name using the number keys (as on a mobile phone).
• Select the language you want to use in ‘Terminal Settings’, ‘Language’.
• Please make sure that ‘Dual Monitor’ is set to ‘On’ in the ‘Utilities’ menu.
• To activate MultiSite and/or Presenter, enter an option key (see paperwork accompanying your system), see
‘Terminal Settings’, ‘Software Options’.
• Press CONNECT on the remote control. A dial tone should be heard if the network is active.
• Press the
V
OLUME
keys on the remote control to adjust the volume to a level of your choice.
THESE SETTINGS ARE ESSENTIAL
FOR OPTIMAL SYSTEM SET-UP.
NOTE