Filter
Top Products
46
TANDBERG Videoconferencing SystemGeneral use
PC Presenter
Plugging a PC into the system is made extremely simple through the PC Presenter, avoiding the need for any
additional hardware such as a projector, PC/Video converter or extra cables.
• Connect the pre-connected VGA cable to your PC (VGA Output).
• Start your PC.
• Press PC on your remote control.
• Press SELFVIEW until the indicator ‘Selfview‘ is displayed on your main monitor (single monitor system) or until
you see the PC image on the second monitor.
If no PC image is displayed on your monitor, make sure that your PC transmits the image to the VGA Output, and
that the PC transmits a supported VGA-format (see tip below). Consult your PC-operating manual to see how to
transmit a VGA image from your PC (typically: Fn+F5).
PC SoftPresenter
PC SoftPresenter is used to display PC images on your system without using a VGA cable (PC Presenter). The
TANDBERG video conferencing system and your PC must be connected to a LAN. In addition, VNC (Virtual
Network Computing) server software must be installed on the PC.
To show the PC image:
• Start the VNC software on your PC.
• Press PC on your remote control. Use UP/DOWN to activate PAGE UP/PAGE DOWN on the PC.
For setup information and details, see ‘VNC Settings’ in ‘Advanced use’.
‘PC: VNC’ MUST BE SET IN ‘VIDEO SETTINGS’.NOTE
IN ORDER TO SHOW PC IMAGES WITH SUPERIOR QUALITY, THE
VGA INPUT ON THE PLASMA MONITOR WILL BE ACTIVATED WHEN
PRESSING PC.
NOTE
VGA-FORMATS SUPPORTED (VESA COMPLIANT)
·VGA 640X480 60,72,75,85 HZ
·SVGA 800X600 56,60,72,75,85 HZ
·XGA 1024X768 60,70,75 HZ