Filter
Top Products
14
TANDBERG Videoconferencing SystemInstallation
Unpacking the Base
Due to the weight of the system, the base should be placed in its permanent location as soon as it is unpacked.
Unpacking and Installing the Monitor Rack
Lift the Monitor Rack out of the box. Do not remove the straps or packaging that are around the rack. Place the
rack on top of the base. Make sure that the cables from the base do not get stuck in between.
You will find 4 bolts sticking out at the rear end of the base. Use the 4 nuts to fasten the Monitor Rack in place.
You can now remove the straps and packaging from the Monitor Rack.
Carefully flip down the plastic cover. 4 hexagonal-shaped screws should be used to secure the Monitor Rack to
the top of the Base. There are 2 holes located on each side.
IF THE SYSTEM IS TO BE PLACED AGAINST A WALL, IT IS POSSIBLE TO REDUCE THE SIZE OF THE BOTTOM PLATE. THE REDUCTION SHOULD BE DONE
BEFORE THE REST OF THE INSTALLATION IS CARRIED OUT.
THE FRONT COVER IS MADE WITH PLASTIC AND SHOULD BE TREATED WITH CARE.
NOTE
NOTE