Filter
Top Products
60
TANDBERG Videoconferencing SystemAdvanced use
Audio Outputs
Audio out 1 is intended for connection to TANDBERG Natural Audio, televisions or audio amplifiers.
Audio out 2 is intended for connection to audio recording equipment or to a telephone add-on hybrid. The signal is
a mix of audio from both the far end and local end (not from Audio in 5).
Audio out 3 is intended for connection to a VCR or other recording equipment. The signal is a mix of audio from
far end and local end (not from Audio in 6).
Audio Module: Select Natural Audio Module according to the type of Audio Module installed.
NEVER CONNECT AUDIO OUT 2 OR AUDIO OUT 3 TO A LOUDSPEAKER PLACED IN THE SAME ROOM AS THE MICROPHONES CONNECTED TO THE
SYSTEM. DOING THIS WILL CAUSE “HOWLING” AND POSSIBLE DAMAGE TO THE SPEAKER SYSTEM.
If an output is ‘Off’, no audio will be sent to that output.
Level Settings - Outputs
Adjust the audio output levels according to the parameters of the external audio equipment connected. These
levels should only be adjusted when installing new audio equipment. The default settings are correct for the
TANDBERG Natural Audio module and for most consumer electronics devices (televisions, VCRs, etc.).
The volume keys on the remote control adjust the level of output 1 (the speaker output). The volume control has
no effect on outputs 2 and 3.
NOTE