Filter
Top Products
TANDBERG Videoconferencing System
17
Installation
Monitor configuration
Power up the codec and the monitors. Use the monitor remote control to set the monitors to Y/C.
Securing the cables
It is important that the wires are secured inside the base so that they don’t get in the way of the covers, which are
to be screwed on to the back.
Attaching the back covers
Screw the two back covers on to the base. The lower of the two covers should be attached first.
ATTACH THE POUCH FOR THE REMOTE CONTROL TO THE BACK OF ONE OF THE MONITORS. THE REMOTE CONTROL CAN THEN BE
STORED IN THIS POUCH.
6. LAN cable
• To use the system on LAN, connect a LAN cable from the ‘Ethernet’ connector on the system to your LAN.
TIP