1 – Introduction
32 TASCAM CC-222MKIV
7 – Cassette operating
Dubbing to tape from the middle of a CD
The above procedure describes the playback and recording
from the start of a disc (or the start of a programmed play-
back list).
To record from a point other than the ones above:
1 Locatethedisctothepointwheretheplaybackisto
start.
2 PressthediscPAUSEkeytopauseplaybackatthe
pointwheretheplaybackistostart.
3 Ifrecordingistostartatthebeginningofthecas-
sette,makesurethecassetteisstopped,otherwise,
locatethecassettetotheappropriatepositionwhere
recordingistostart,andenterrecordstandby
mode.
UsingtheheadphoneswiththeMONITORswitchset
to MIXwillhelphere.
4 PresstheDUB 2key.Playbackstartsonthedisc,
andrecordingstartsonthecassette.
Recording tapes from the PHONO deck
To record from an external record deck connected through
the
RIAA PHONO inputs:
1 Prepareforrecordingasdescribedabove(loada
tape,settheREVMODE,etc.).
2 PresstheMENUkeyuntilthePHONO>XXX menu
itemisshown.
TurningtheMULTI DIALorpressingtheSKIPkeys
ontheremotecontroltoselecteitherTAPE.
PresstheMULTI DIALorENTERontheremotecon-
trolunit.
3 PressthePHONOkey.ThePHONOindicatorlightson
thedisplay.
Ifthetapeiscurrentlyinstopmode,thetapere-
winds,andthedeckentersrecordstandbymode
(abouteightsecondsfromthestartofthecassette,
toallowforleadertape).
Ifthetapedeckisalreadyinrecordstandbymode,
itwillremaininrecordstandbymode.
4 Startplaybackoftherecord.
5 StartrecordingwitheitherthePLAYorPAUSEkey.
PressSTOP(cassettedeck)tostoptherecording.
The STOPkeyistheonlykeywhichisenableddur-
ingphonorecording.
NOTE
It is not possible to perform phono recording as
described above under the following circumstances:
a tape is not loaded or the tape is write-protected (the
phono to tape function is disabled with no recordable
tape inserted), or the tape is not either stopped or in
record standby mode.
Only recording as described above is possible from
the RIAA PHONO sources to tape. Manual recording is
not possible.
Erasing tapes
Anything previously recorded on the tape will automatical-
ly be erased when you make a new recording on it. It can
also be erased by “recording” on it with the
INPUT level
control set to “0”.
Other recording features
Recording silences between items
When recording, press and release either of the REC
MUTE
keys (main or remote). With the tape moving, the
record source is muted for about four seconds (the display
record indicator flashes), and the deck then enters record
pause mode. Press
PAUSE or PLAY to re-start recording.
If the
REC MUTE key is pressed while the deck is in record
standby mode, four seconds of silence will be recorded on
the tape, and the deck will return to record standby mode.
If the
REC MUTE key is held and pressed for longer than
four seconds while recording is in progress, silence is
recorded on the tape while the key is held down. The deck
enters record standby mode when the key is released.