Filter
Top Products
1 – Introduction
TASCAM CC-222MKIV 33
7 – Cassette operating
Pitch control
The tape speed can be controlled using the PITCH
CONTROL
.
Turning this to the right of the center position results in
faster tape speed (higher pitch), and turning to the left
of the center position results in slower tape speed (lower
pitch). The maximum is 10% away from normal.
The center “neutral” position is marked by a click detent.
Tape counter
Other tape functions and features
The tape counter value increments when the tape is moving
from left to right, and decrements when it moves from right
to left.
Use either of the
RESET keys (main or remote) to reset the
value to 0000.
When the counter has been set to 0000, this position can be
reached easily by pressing either of the
RTZ keys (main or
remote). The tape fast forwards or fast rewinds to the 0000
mark.
NOTE
If the current tape position is too close to the 0000
mark (greater than 9995 or less than 0004), this func-
tion is not available.
OUT2 setting (TAPE or AUTO)
Using the OUT2 menu, you can assign the LINE OUTPUTS2
to
TAPE or AUTO (the default setting is TAPE).
If
TAPE is selected, the unit outputs only the cassette tape
when playing back or monitoring.
If
AUTO is selected, the unit outputs either the cassette
tape or disc automatically when playing back or monitor-
ing. However, note that if both are playing at same time,
the cassette takes priority (the disc will not be heard
through these outputs).
1. PresstheMENUkeyuntilthemenuitemOUT2>XXX
showsuponthedisplay.
2. TurntheMULTI DIAL to select TAPEorAUTO.
3. Push the MULTI DIALtoconrmandexitthemenu
operation.