Filter
Top Products
Error Possible cause Measures
No picture, no sound,display is off no supply voltage check mains cable and
connector
No picture, no sound,display is on cable connection is broken or check all cable connections
missing (see 3 „connection“)
television set is set to the wrong set channel 39 on the
channel television set (see operating
instructions of the TV set)
LNB has no power supply check LNB feed (see 5.2.3.4.
„LNB voltage“)
outdoor unit is adjusted incorrectly adjust outdoor unit correctly
selected channel cannot be received choose a different channel
by the outdoor unit (see 4.1.2 „channel selection“)
All satellite channels display „wavy receiver transmits on the same change transmit channel on
lines“. channel as a programme that is the receiver (see 3.1 „outdoor
received via antenna unit and television set“)
A channel that ist received via receiver transmits on the same
antenna display „wavy lines“ channel as a programme that ist
received via antenna
The picture is full of black and heavy rain or snow remove the snow from the
white points („little fish) outdoor unit
outdoor unit ist adjusted incorrectly adjust outdoor unit correctly
the polarizer is adjusted incorrectly set „skew“ (see 5.2.3.4 „LNB
voltage“)
paraboloidal-type reflector is too use a bigger paraboloidal-type
small at the receiving location reflector
Picture o.k., wrong sound a radio channel is set switch to TV channel (see
4.1.2 „channel selection“)
Sound o.k., no picture channel is encoded connect the adequate decoder
(see 3.4 „external decoder“)
Picture o.k., no sound television is set to mute mode check the volume on the
television set
receiver is mute or volume is too check the volume on the
low receiver (see 4.1.3 „volume“)
Channel picture or sound disturbed, audio or video settings have been copy channels of the prepro-
though working o.k. before modified grammation again (see.5.
„programmation“)
now the channel is encoded connect the adequate decoder
(see 3.4 „external decoder“)
channel is no longer broadcasting no measures
The display indicates „C“ instead of the table with the preprogrammed switch the channel positions
„F“ channels is activated (see 4.1.2 „channel selection“)
Your individual programmation has the complete table has been deleted load a preprogrammed table
disappeared (see 5 „programmation“)
Some of the channels cannot be set the corresponding channels have rememorize the channel (5
with the channel keys been deleted „programmation“)
A connected decoder does not invalid code or invalid smart card observe the decoder’s
decode operating instructions
wrong scart input check the connection (see 3.4
„external decoder“)
incorrect decoder signal has been correct the setting (see 3.4
set „external decoder“)
The internal decoder does not see 4.4.5 „automatic on screen see 4.4.5 „automatic on screen
decode display“ display“
7. Troubleshooting notes
TechniSat EC 4004
34
*EC 4004 ENGL. 14.12.1999 10:01 Uhr Seite 34