Filter
Top Products
e) If your television set does not have an AV input, you can also connect the receiver's antenna output to the
antenna input of the television set using an antenna cable. Plug the cable coming from the antenna into
the antenna input.
Your television set has to be adjusted to the transmission channel of the receiver.
> switch to "TSG" (test signal) on the receiver
> select a free channel on your TV set
> adjust the television set to channel 39
If channel 39 is occupied by a channel that can be received via antenna, you can adjust a
different transmission channel in the range of 32 to 42.
> adjust unoccupied channel on the television set
> use a little screwdriver to turn " + - " (channel) until the test picture is displayed
CH
> set the modulator on the receiver to "video"
> possibly precise adjustment on the television set
3.2 Hifi amplifier
f) In order to achieve maximum sound quality the receiver can be connected to a Hifi amplifier. Use an ade-
quate amplifier input (e.g. CD, Aux; Warning, the "phono" input is not appropriate!) to link it with the recei-
ver's audio R/L cinch jacks.
3.3 Video cassette recorder (VCR)
g) Connect the video recorder to the SCART input "VCR".
When the video cassette recorder is used, it supplies the receiver with a switch signal in
order to redirect its audio and video signals to the SCART input "TV" and, when the recei-
ver is switched on,also to the antenna output.When using the video recorder via the SCART
output, the receiver should not be set to a MAC channel in order to avoid image interfe-
rences.
3.4 External decoder
h) In addition to the installed Eurocrypt decoder you can connect another decoder to the
SCART input "DECODER". To adjust to different decoder types you can select "DEC.MODE"
on the receiver's back panel to switch between 4 decoder signals.
A: unapplied, unfiltered, without deemphasis ("flat")
B: unapplied, unfiltered, with deemphasis (baseband)
C: unapplied, filtered, with deemphasis (video unapplied)
D: applied, filtered, with deemphasis (video applied)
Find out from the operating instructions of the decoder which signal is necessary.
When the channel also encodes the audio signals,set the switch "AUDIO INT/EXT" on the recei-
ver’s back panel to "EXT" and the audio signals of the receiver are led to the decoder.
When the external decoder supplies an RGB signal (e.g. text displays) the two left display ele-
ments indicate "= =" on the receiver.
TechniSat EC 4004
7
*EC 4004 ENGL. 14.12.1999 9:56 Uhr Seite 7