Filter
Top Products
10
Connections and initial set up
DTH 8000 / satellite or cable receiver settings
1.
Switch on your TV set,your DTH 8000, then your satellite or cable receiver.
2. Place the receiver on channel 002.
With your DTH 8000’s remote control, carry out the following settings:
3. If the main menu is not displayed, press the MENU key on the remote control.
4. Select the Setup line using the or keys, and press OK to validate.
5. Select the Installation line using the or keys, and press OK to validate.
The Interactive setup line is already selected. Press
OK.
6. Choose a display language for the following screens.
7. Select your country of residence using the or keys, and press OK.
The Automatic line is already highlighted,press
OK.
The screen which appears is a set-up screen for the allocation of input terminals
8. If you connected your devices as indicated on page 9, check that AV2-SAT-CABL has been
allocated to Satellite Receiver,or Cable Receiver otherwise change the allocation using
the key.
Note: Cable Receiver or Satellite Receiver:to
connect with a satellite or cable receiver terminal on the AV2
socket of your DTH 8000 (connection shown on page 9).The
other settings are explained on page 5.
9. Then select the line Done and press OK.
Note: an installation window will appear.A cursor shows the
progress in the set-up of the channels.When all the channels
that you can receive in your area have been stored, 100 % is
indicated.
Press OK.
From now on, follow on-screen instructions appearing in the various windows. If need be,
refer to the additional explanations given below.
DTH8000_en(EB-UB) 18/12/03 14:48 Page 10