Filter
Top Products
GB
GB
15
Use
• start time of the programme,
• end time of the programme,
• the date, if the recording is not to take place on the same day.
" You can complete your record timer by selecting the following options: recording
triggered by VPS or PDC signals, daily or weekly repeated recording, recording
speed, sub-title recording.
5 Switch off the video recorder to put it into standby mode.
When the video recorder is programmed
When the video recorder is on standby waiting for the time at which the recording shall be
triggered, a special indication ( ) is to be seen on its display. Then, you cannot operate the
video recorder any longer unless you quit this mode by pressing key B (3).
Deleting a programmed recording
1 Display the SUMMARY menu with MENU (15) key, then select the Record Timer line
with ▼ (11). Validate with OK (13).
2 Press ▼ (11) to select the Timer Review list, then validate with OK (13).
3 With ▲ (9) and ▼ (11) keys, select the programming to be deleted then press key 0000
(21).
" Programming is deleted.
Recording programmed by a connected external unit
☺
The recording of a programme can be triggered by a satellite receiver or any other unit supporting
this feature and connected to socket AV1 or AV2 by means of a Scart cable. This connection scheme
prevents you from having to programme both units.
1a Programming by external Timer : tick off the External timer box in the menu
P
REFERENCES (page 20) to trigger the recording via socket AV1.
1bProgramming by the R
ECORD TIMER menu : programme the connected unit and, in the
video recorder R
ECORD TIMER menu, only select either socket AV1 or AV2, without
indicating start and end times.
2 Switch the video recorder to standby with B (3) key.
Error messages likely to occur when programming
# No timer available
You need to free one of the memories in order to programme again.
# When you programme two recordings with overlapping time periods, the menu TIMER REVIEW
comes up and makes the programmed recordings flash.
Delete the programme recordings with the 0000 (21) key.
# Incomplete programming
Check that you have completed all the requirements for the recording (start time, end time,
etc.).
r93s_GB01 9/06/00 11:28 Page 15