Filter
Top Products
Chapter 6: Using the TV’s features
0
Displaying TV status information
To display TV status information using RECALL:
Press on the remote control.
The following information will display (if applicable):
Current input (ANT/CABLE, VIDEO 1, etc.)
If ANT/CABLE is the current input, either “CABLE” (for
cable TV) or “ANT” (for over-the-air broadcasts).
Channel number (if in ANT/CABLE mode)
Channel label (if set)
Digital signal strength indicator (bar graph in lower right
corner of box; for ATSC signal only)
Stereo, Mono or SAP audio status (when HDMI input
mode, Dolby Digital or PCM)
Video resolution
Aspect ratio of incoming video signal (4:3 or 16:9)
V-Chip rating status
Game Timer (if set)
To close the RECALL screen:
Press again.
To display TV status information using INFO:
Press on the remote control.
The following additional information will display for off air
digital channels (if applicable):
Title
Duration
Detailed description
Note: The location of the banner can be moved to the top or
bottom of the screen by pressing p or q while the RECALL
or INFO display is on-screen. (The last position will be stored
to memory.)
•
•
•
•
•
•
•
•
•
•
•
•
•
Understanding the auto power off
feature
The TV will automatically turn itself off after approximately
15 minutes if it is tuned to a vacant channel or a station that
completes its broadcast for the day. This feature functions in
ANT/CABLE mode only.
Understanding the last mode
memory feature
If the power is cut off while you are viewing the TV, the
Last Mode Memory feature automatically turns on the
TV when the power is resupplied.
Note: If it’s possible, and you will be away from the TV for an
extended period of time you should unplug the power cord.