Filter
Top Products
Initial Setup and Menu
57
Model Name
1 Press the GREEN button.
The Model Name screen will appear.
2 Use the
p
/
q
(arrow) buttons to select the model name then
press the OK button.
v
Select a eld and press the OK button to show the
software keyboard. Enter the rst few characters of the
model name and press the GREEN button. The model
name starting with the entered characters will appear on
the Model Name screen.
NOTE
You do not need to set both model name and code set. If you select Model
Name and press OK, it will take you directly to the Input & Mode key
screen and skip the code set.
The code set should be selected only when you know the code set.
Code Set
1 Use the
t
/
u
(arrow) buttons to select the code.
v
After the code is selected, press the RED button to show
the Test screen. The test will start automatically.
NOTE
If a model has more than one Code Set, a message will appear stating “This
model has more than one Code Set. Please select and test your preferred
Code Set.” You will need to choose a code set using the
p
/
q
(arrow)
buttons and perform the Test option to ensure the correct Code Set has
been selected.
2 Press the OK button.
Input & Mode Key screen will appear.
Input & Mode Key
1 Use the
t
/
u
(arrow) buttons to select the TV input
to which
the IR device is connected
.
v
--- (Appears when Device Type is set to Receiver, Misc
Audio or Amplier)
v
ANT/CABLE
v
Video1
v
Video2
v
ColorStream HD
Performing the initial setup