Toshiba BDX2500KU Blu-ray Player User Manual


  Open as PDF
of 60
 
32
Function setup

Speaker Setting
Once the speakers are connected to the system and properly
configured, you can check to verify that the connections
to the speakers are correct by running an audio speaker
test.
To run this test, follow the instructions described as below:
1. In the main menu of Settings, press
button, then use
/ button to select Speaker, then press OK.
Note: This setup menu item has no effect unless:
• Ifyouhaveselected‘BitstreamMixed’intheaudio
menu, these menu choices will have no effect. (Each
channel’s full audio spectrum will be sent to each speaker,
regardless of the speaker size selected)
• Ifyoudon’tknowthetypeofspeakersattachedtoyour
surround sound system, consult the manual for your
speaker system.
2. Use
/ / / to highlight the desired speaker, then
press OK to enter.
3. Press
/ to choose the desired audio signal, and then
press OK to confirm.
Front Left & Right Speakers:
• Bysettingthefrontleftspeaker’ssize,thefrontright
speaker’s size is automatically changed to match.
• Thefrontspeakerscannotbeturnedoff.Theycanonly
besetto‘Small’or‘Large’.
Center Speaker:
• Ifthefrontspeakershavebeensettosmall,thecenter
speakercanonlybesetto‘small’or‘Off’.
• Settingaspeakerto‘off’willresultinnosoundbeing
delivered to that speaker.
Subwoofer:
• Ifyoudon’tknowthecrossoverfrequencyofyour
subwoofer, consult the manual for your speaker
system.
Surround Left & Right Speakers:
• Bysettingtheleftsurroundspeaker’ssize,theright
surround speaker’s size is automatically changed to
match.
• Ifthefrontspeakershavebeensettosmall,thesurround
speakerscanonlybesetto‘Small’or‘Off’.
Rear Left & Right Speakers:
• Bysettingtheleftrearspeaker’ssize,therightrear
speaker’s size is automatically changed to match.
• Ifthefrontspeakershavebeensettosmall,therear
speakerscanonlybesetto‘Small’or‘Off’.
4. Use
/ / / to move the highlight box to the Test
button on the bottom, then press OK. A message will
appear.
5. Press
/ to choose the desired audio signal. You can
select between Pink, 1kHz Sine and White.
6. Press OK to begin the speaker test. The audio signal will
be sent to a different speaker every approximately every
two seconds. The audio test will highlight which speaker
is supposed to be getting the sound on the screen.
7. To stop the audio test, press one of the
/ / /
buttons.
8. Press
or RETURN to go to the previous menu.
 previous next