Filter
Top Products
27
Various settings
Setting the Video / Setting the Audio
Line1 Input/Line2 Input
This unit comes with an S-Video input jack and Video
input jack. When you use an S-Video or Video input jack,
you must select the input mode.
Select “Line1 Input” (“Line2 Input”) and select the mode
from the below.
S-Video
The video signal is input from the S-Video input jack
priority.
Video
The video signal is input only from the Video input jack.
E.B.L
To select the black level of playback pictures, set your
preference and monitor’s ability.
On: Enhanced grey scale (0 IRE cut off)
Off: Standard grey scale (7.5 IRE cut off)
NOTE:
The E.B.L function only works when playing back DVD-
Video, DVD-RAM/RW/R or Video-CDs.
This section describes audio settings.
Preparation:
•Turn ON the TV and set it to the video input mode.
• Select “AUDIO” from “Setup Menu”. For the proce-
dure, see steps 1 to 3 in “Using the Setup Menu” on
page 23.
Dolby Digital Output
DRC
Surround
SAP
SETUP
Select
End
Enter Back
ENTER
RETURN
AUDIO
Dolby Digital
PCM
Dolby Digital Output
Select from the following methods of outputting the au-
dio of discs that were recorded with Dolby Digital.
Dolby Digital: Outputs in Dolby Digital sound.
PCM: Converts the sound to PCM and out-
puts it.
NOTE:
Select PCM if you are connected to an audio amplifier
and the amplifier is not Dolby Digital compatible.
DRC
DRC (Dynamic Range Control) enables you to control
the dynamic range so as to achieve a suitable sound for
your equipment.
Select “DRC” and select the level from the below.
Max: Full dynamic range is maintained.
Std: Full dynamic range is reduced.
TV: Dynamic range is reduced.
NOTES:
• This function works only during playback of Dolby Digi-
tal recorded discs.
• When you listen to the sound from TV’s speaker, we
recommend that you select “TV”.
• The level of Dynamic Range Reduction may differ
depending on the DVD.
Surround
Sound that is not recorded in the surround mode will be
changed to artificial surround sound output.
Select “Surround” and select “On” to activate the sur-
round function. Select “Off” to cancel the surround func-
tion.
NOTE:
This function does not work with a video tape.
SAP (Second Audio Program)
This unit is fitted with an SAP broadcast system that
enables you to switch to a second audio program while
viewing a selected channel.
This function applies only when the program is broad-
cast in multiple languages through the SAP broadcast
system.
Select “SAP” and select “On” to activate. Select “Off” to
cancel.
Listening to SAP
When the unit is turned on or a channel selection is
made, make sure “SAP” appears on the screen. This
means that “Second Audio Program” broadcasting is
available.
2H5-01 P22-30 7/25/05, 23:1927