Filter
Top Products
NOTICE
PREPARATION
INTRODUCTION
RECORDING
OPERATION
PLAYBACK
OPERATION
39
1
Turn the power ON for the monitor TV.
PLAYBACK
2
Insert a tape which has been recorded on.
3
Press the PLAY button.
4
Select the playback time mode.
123
H
PLAY
SP
TIME MODE
SET
+–
PLAY
STOP
PLAYBACK OPERATION
TIMER
POWER
EJECT
VIDEO MODE
TAPE REMAIN
TIME LAPSE VCR
4Head 168Hour
DISPLAY
PLAY
TIME MODE
SET
SHIFT
TRACKING
LOCATION SELECT
COUNTER
ALARM RESETMEMORY
AUTO B/W
COLOR
REMOTE
OFF REMOTE OPTION
BUZZER
ON OFF
REC
REC CHECK
+–
PICTURE
SOFT SHARP
Tracking Adjustment
Use the , TRACKING button to adjust when noise appears on the playback screen.
Notes:
When restart record is selected, and a power failure occurs, the VCR will automatically go into record mode when power is restored.
When the PAUSE button is pressed during playback, the VCR will go into still mode. To return to playback, press the PAUSE or
PLAY button. If the VCR is in still mode for longer 10 minutes the VCR will automatically resume normal playback.
When playing back tapes recorded in various time modes, the picture may be slightly unstable depending on the time mode.
Reverse playback is released after 1 minute and the VCR returns to normal playback.
The time mode cannot be changed during reverse playback (only in SPA2 and EPA6).
When playing back a tape that has been recorded in the modes which are excepted for
SPA2 and EPA6, pay attention to the
following points.
• The picture may be somewhat horizontally unstable however, this is not a malfunction of the VCR.
• The upper section of the picture on the monitor screen may be distorted. This is not an abnormality.
The picture may be vertically unstable during playback in the modes which are excepted for
SPA2 and EPA6. This is not an abnormality.
The advance Slow/Still playback images are Clean Slow/Still excepted of the bellow 2 images.
• The picture may be unstable during playback for images at Field Advance Slow/Still in
SPA2 mode recorded, or for images at
Reverse Field Advance Slow/Reverse Still in EP mode. But those are not abnormality.
The picture may be unstable during reverse playback, but this is not an abnormality.
When returning to normal playback after picture search, the picture may wobble for a short while.
The screen will disturb when the tape passes from a SP record area to EP record area, or from an EP record area to SP record
area in one of the following playback modes:
SP24 ~ SP168, EP30 ~ EP168 and Field advance slow. If this occurs, playback
once in the
SPA2 or EPA6 mode, and then return to the original mode.
Press either or TRACKING button so that a clearer
picture is obtained.
When returning the tracking to a standard adjustment
value, press
and buttons simultaneously.
TRACKING
Recording time mode
SPA2, SPA12, SPA24, SP24, SP48, SP72, SP120, SP168,
SPL01, SPL02, SPL03
EPA6, EPA18, EP30, EP48, EP72, EP120, EP168
Time mode for playback
SPA2, SPA12, SPA24, SP24, SP48, SP72, SP120, SP168
EPA6, EPA18, EP30, EP48, EP72, EP120, EP168