Filter
Top Products
RECORDING
OPERATION
PREPARATION
INTRODUCTION
PLAYBACK
OPERATION
NOTICE
TIME DATE SEARCH
Searching a picture at a desired day and time is possible by specifying the day and hour on the MENU screen.
The VCR automatically records the current date and time (day/hour/minute). Accordingly, make sure before recording that the date
and time is exactly adjusted.
Search Operation
In case of searching the picture at day of 28, 17:30 minutes in
reverse direction;
1
Press the DISPLAY
button.
2
Press the SHIFT button
to blink TIME DATE
SEARCH and press the
SET button.
3
Press the SET button to
set the DAY to 28 and
press the
SHIFT
button.
4
Press the SET button to
set the HOUR to 17 and
press the
SHIFT
button.
5
Press the SET button to
set the MINUTE to 30.
6
Press the SHIFT button
to blink the REVERSE,
and press the SET
button.
M E N U
CLOCK ADJUST
SETUPSETUP
DISPLAY MODE
END=[DISPLAY]
PROGRAM
ALARM RECALL
TIME DATE SEARCH
REVERSE
SEARCH FORWARD
MINUTE 00
TIME DATE SEARCH
DAY 01
MENU=[DISPLAY]
HOUR 00
FORWARD
MINUTE 00
REVERSE
TIME DATE SEARCH
DAY 28
MENU=[DISPLAY]
HOUR 0
FORWARD
MINUTE 00
REVERSE
TIME DATE SEARCH
DAY 28
MENU=[DISPLAY]
HOUR 17
FORWARD
MINUTE 30
REVERSE
TIME DATE SEARCH
DAY 28
MENU=[DISPLAY]
HOUR 17
FORWARD
MINUTE 30
REVERSE
TIME DATE SEARCH
DAY 28
MENU=[DISPLAY]
HOUR 17
DISPLAY
TIME MODE
SET
SHIFT
TRACKING
LOCATION SELECT
+–
DISPLAY
TIME MODE
SET
SHIFT
TRACKING
LOCATION SELECT
+–
DISPLAY
TIME MODE
SET
SHIFT
TRACKING
LOCATION SELECT
+–
DISPLAY
TIME MODE
SET
SHIFT
TRACKING
LOCATION SELECT
+–
DISPLAY
TIME MODE
SET
SHIFT
TRACKING
LOCATION SELECT
+–
DISPLAY
TIME MODE
SET
SHIFT
TRACKING
LOCATION SELECT
+–
42
Note:
Time date search is not carried out if the time adjustment has been not completed.
Time date search is not carried out for tapes recorded by a unit which can’t automatically record data of time and date.
Time date search will not operate when searching a section of tape that has an alarm on it. In this case perform alarm search.
Time date search may cause a time error listed in the following to the specified time.
Time date search may not be carried out in the areas at REC start and REC end shown below.
REC start REC end
less than
1min.
less than A
Record mode
SPA2, EPA6, SPA12,
EPA18, SPA24, SP24,
EP30, EP48, EP72, EP120
SP48, SP72, EP168
SP120
SP168
Time error to the
specified time at
maximum
1 min.
3 min.
4 min.
5 min.
A (Not carry out in
the REC end area
at maximum)
1 min.
3 min.
4 min.
5 min.