Filter
Top Products
43
Figure 4.7.6
2) Open the Intensive Recording Options. Enable the Intensive-On-Sensor option and then select the desired
Pictures Per Second for both the Intensive and Non-Intensive Channels. You can also adjust the Resolution and
the holding duration for the Intensive Channel.
3) Save the Intensive Recording settings by selecting the APPLY button.
4) Open the Schedule Menu and press the SENSOR button to open the Sensor Schedule window.
5) Enable the sensor you associated with the Intensive Recording by creating a schedule for it.
6) Press the APPLY button and exit out of setup
4.7.5 Audio
The Surveillix DVR is capable of recording up to 8 channels of audio.
AUDIO FEATURES:
8000 Hz playback in Live Mode
Audio input level should be 1 Vpp
Up to 48000 Hz playback in search mode
Mono Sampling
Line-In type (Requires Amplification)
DATA SIZE (Per channel)
1 Second: 1625 bytes
1 Minute: 97,500 bytes
10 Minutes: 975,000 bytes
1 Hour: 5,850,000 bytes
1 Day: 140,400,000 bytes (Approx 140MB)
Audio Enable/Disable – Enables the audio recording.
4.7.6 Video Loss Alarm
The DVR supports a Video Loss Alarm function which allows an Alarm Event to occur when a camera loses signal. The
lost signal can be due to Power failure to the camera, the camera cable being cut or unplugged, or the camera being
damaged in some way.
In order to use Video Signal Loss detection, cameras must either be turned ‘ON’ or ‘OFF’. This is because the DVR
needs to know which cameras it should expect to receive signals from. To turn camera(s) ‘ON’, open FRAME SETUP,
and set the Frames Per Second to anything above zero. By designating zero frames per second you are essentially
saying that the camera is not going to be used by the DVR.
Video Port – Refers to the output channel. The
Ports use RCA jacks.
Cameras – The camera buttons allow selection
of cameras to sequence on the selected Port.
Motion/Sensor Event – This option allows
immediate output of a Motion or Sensor Event
on the selected Port.
Event Holding Time – The Event Holding Time
specifies the duration for which the Motion or
Sensor Event will be displayed.
Auto Switching Time – The Auto Switching
Time specifies the duration which the selected
cameras will sequence one to the next.
USE – Enables the selected Port.
1
1
Figure 4.75
Figure 4.7.5
Audio
Figure 4.7.6