Filter
Top Products
User’s Manual 3-33
PORTÉGÉ M750
8. Seat the memory module cover in place and secure it with one screw.
Figure 3-17 Seating the memory module cover
9. Install the battery pack - refer to Replacing the battery pack section in
Chapter 6, Power and Power-Up Modes, if required.
10.Turn your computer over.
11. Turn the computer on and make sure the added memory is recognized -
to confirmed it, Start -> Control Panel -> System and Maintenance ->
System icon.
Removing a memory module (Slot B)
To remove the memory module, follow the steps as detailed below:
1. Set the computer to Boot Mode and turn its power off - make sure the
Power indicator is off (refer to the Turning off the power section in
Chapter 1, Getting Started, if required).
2. Remove the AC adaptor and all cables and peripherals connected to
the computer.
3. Close the display panel.
Align the grooves along the edges of the memory module with the locking
tabs on the connector and insert the memory module into the connector
firmly - if you find it difficult to install the memory module, gently prise the
locking tabs outwards using the tip of your finger.
Please also ensure that you hold the memory module along its left and
right hand edges - the edges with the grooves in.
Take care to ensure that the memory module cover is firmly closed.
Screw
Memory module cover
Always make sure the display panel is closed in Laptop mode before
turning the computer upside down.