Filter
Top Products
User’s Manual 3-29
PORTÉGÉ M750
11. Screw in the two screws and replace the memory module cover.
Figure 3-12 Seating the memory module cover
12. Insert the tabs on the front of the keyboard into the corresponding
notches on the computer and place the keyboard down.
13. Replace the keyboard and secure it using the two screws.
■ Slot A is reserved for the first memory module. Use slot B for expansion
memory modules. If only one module is installed, use slot A.
■ When inserting or removing memory modules, make sure to use the
correct slot (A or B).
■ Align the grooves along the edges of the memory module with the
locking tabs on the connector and insert the memory module into the
connector firmly - if you find it difficult to install the memory module,
gently prise the locking tabs outwards using the tip of your finger.
Please also ensure that you hold the memory module along its left and
right hand edges - the edges with the grooves in.
Memory module cover
Screws
When seating the keyboard, be sure to connect the circuit board if the
keyboard ribbon cable was pulled out while you were removing the
keyboard.
Be sure to use all two screws removed in step 7. Make sure no screw was
dropped into the computer. Make sure no foreign matter can be found
inside the computer.