Filter
Top Products
83
HM196 (E/F) Web 213:276
Chapter 9: Appendix
Note:
• Never subject the lamp unit to excessive shock.
• Never touch the lamp unit glass or otherwise get it dirty.
Doing so may affect the image quality and reduce the
service life of the lamp. See “Cleaning the lamp unit glass”
below.
7 Using a manual Phillips screwdriver, tighten the two lamp
unit screws.
Note: Hand-tighten only. Do not use an electric
screwdriver.
8 Reattach the lamp unit door, making sure to insert the
hooks on the left side of the lamp unit door inside the
opening in the TV cabinet.
9 Replace the screw and tighten using a manual
screwdriver.
10 Plug in the power cord and turn on the TV. After the initial
warmup period (which may take several seconds for full
picture brightness), the TV should operate normally. If
any of the following conditions exist, turn off the TV,
unplug the power cord, and repeat steps 1–9 to ensure that
the lamp unit and lamp unit door are installed correctly:
• No picture
• Dark picture
• TV will not turn on
If, after repeating steps 1–9, the problem still exists:
• In the U.S., call TACP Consumer Solutions at
1-800-631-3811.
• In Canada, locate the nearest Toshiba authorized
service depot by directing your web browser to
www.toshiba.ca; click “Home Entertainment,” and
then click “Support.”
Disposing of the used lamp unit
• Place the used lamp unit in the empty box from the new unit.
• Keep the lamp unit out of reach of children and pets.
• Dispose of the used lamp unit by the approved method for
your area.
CLEANING THE LAMP UNIT GLASS
If you accidentally touch the lamp unit glass or otherwise get
it dirty, wipe it with a lint-free lens cleaning cloth (such as a
cloth for cleaning camera lenses or eyeglasses).
NOTE : Make sure the lamp unit and screws are
installed securely; otherwise, the TV may not turn
on and the lamp life may be shortened.
CAUTION
:
NEVER
clean a hot lamp with any
type of flammable liquid or aerosol cleaning
agent.
Many ordinary cleaning agents (such as
glass cleaners) contain chemicals that may be flammable at
certain temperatures. If the lamp unit is not allowed to cool for at
least one (1) hour, such chemicals may ignite.
Lamp unit screws
(use manual phillips screwdriver only)
Insert the hooks inside the
TV cabinet opening.
Lamp unit door
NOTE: Make sure the lamp unit door is installed
securely; otherwise, the TV may not turn on.
CAUTION: Always handle the lamp unit
with care.
The lamp unit in this TV was designed for safe
replacement by consumers; however, if the lamp unit is
subjected to intentional or accidental abuse (such as
excessive mechanical abuse or handling by children or
pets), the unit may break, exposing sharp edges or pinch
points.
NOTE: The lamp unit contains mercury.
Disposal of mercury may be regulated due to
environmental considerations. For disposal or
recycling information, contact your local authorities or the
Electronic Industries Alliance (www.eiae.org).
Hand tighten using
a manual screwdriver
Lamp unit door
HM196_EN.book Page 83 Tuesday, May 30, 2006 2:18 PM