Filter
Top Products
17 18
ADVANCED SETUP
ADVANCED SETUP
Customizing Your RF10 with
Special Advanced Features
Customizing Your RF10 with
Special Advanced Features
After you’ve finished all your basic setup, you can choose
to make operation easier by customizing the RF10 just the
way you want, using the Special Advanced Setup Features
described in this section.
Customizing Component Names on the LCD Screen
You can easily edit or change the name of any of the eight
COMPONENT buttons on the LCD screen. For example, you
can rename AUX to “LIGHTS” or SAT to “DISH”, etc.
Here’s how:
STEP 1:
Press and hold both the
COMPONENT button you want
to rename and the MENU
button at the same time for
approximately 3 seconds, until
the word “EDIT” is displayed on
the LCD screen. This signals
that you are now in EDIT mode.
IMPORTANT:You now have 30 seconds
to perform the next step while you are
in EDIT mode. If you don’t press a
button within 30 seconds, EDIT will
disappear from the screen, signaling
that you have exited EDIT mode and
you will need to start over.
STEP 2:
The current COMPONENT name
will then appear on the screen,
with the first space/character
blinking on and off. Change the
character by using any of the
NUMBER buttons. Each press
of the same NUMBER button
selects the next character of
that number’s group, as shown
in the diagram below:
STEP 3:
Once the character you want
appears, move to the next space
by pressing the Right ( ) cursor
button. Use the Left ( ) cursor
button to move the blinking
character to the left. Use the
Down ( ) cursor button to
delete the currently blinking
character.
STEP 4:
When you are finished editing
the COMPONENT name, press
the COMPONENT button you
pressed in STEP 1 to save the
changes. The RF10 will respond
by flashing “SAVED” twice, then
automatically return to normal
operating mode.
Customizing Y our RF10 with
Special Advanced Features