Filter
Top Products
7 8
Pre-Programmed Code Method
BASIC SETUP
BASIC SETUP
Pre-Programmed Code Method
COMPONENT
BUTTON
SELECT
BUTTON
Basic Setup - Overview
There are three ways to program the RF10:
> The Pre-Programmed Code Method
> The Pre-Programmed Auto-Search Method
> The Learning Method
The Pre-Programmed Code Method allows you to setup all
the buttons at once, so it’s the fastest and easiest of the
three methods. The Auto-Search Method scans through all
the codes in the RF10, one at a time. The Learning Method
allows you to transfer functions from other remotes (old or
new), one button at a time.
Pre-Programmed Code Method
STEP 1:
The pre-programmed 3-digit
codes are found in the back of
this Manual on page 38. The
codes are listed by Component
category (i.e., TV, VCR, DVD,
etc.), then by brand name. For
instance, if you want to locate
a code for a Sony TV, first
locate the TV category, and
then look for the Sony brand.
Once you have located the
3-digit code (or in some cases,
several code numbers) for the
Component that you want to
operate with your RF10, write
them ALL down on a piece of
note paper. It’s important that
you write down all the codes
because only one code is going
to work for you.
STEP 2:
Now, turn on the Component you
want to program… let’s say your
TV to start. Look up your TV’s
manufacturer setup code from
your reference list.
STEP 3:
Press and hold the
COMPONENT button (in this
case TV) and SELECT button at
the same time for approximately
3 seconds. The LCD screen will
display “SET” signaling that you
are now in Setup mode and
ready to program your TV.
IMPORTANT:You now have 30 seconds to
perform the next step while you are in
SETUP mode. If you don’t press a button
within 30 seconds, SET will disappear
from the screen, signaling that you have
exited setup mode and you will need to
start over.