Filter
Top Products
29 30
Erasing Commands
ERASING COMMANDS
ERASING COMMANDS
Erasing Commands
ENT
BUTTON
COMPONENT
BUTTONS
PAUSE
BUTTON
COMPONENT
BUTTONS
Erasing All Learned Commands in One Component
STEP 1:
Press and hold both the
COMPONENT button where the
command is stored and the ENT
(Enter) button at the same time
for approximately 3 seconds,
until the word “LEARN” is
displayed on the LCD screen.
IMPORTANT:You now have 30 seconds to
perform the next step while you are in
LEARN mode. If you don’t press a button
within 30 seconds, LEARN will disappear
from the screen, signaling that you have
exited erase mode and you will need to
start over.
STEP 2:
Press and hold both the
COMPONENT button you want
to erase and the PAUSE button
until the display flashes ERASE
eight times, followed by SAVED.
Release the buttons and the
RF10 will then automatically
return to normal operating
mode.