Filter
Top Products
COMPONENT
BUTTON
ENTER
BUTTON
Learning Method
The RF10 can actually ‘learn’ commands from other remote
controls (old or new), one-button-at-a-time, so it will never
become obsolete. RF10 is the last remote you’ll ever need!
Just follow these simple steps:
STEP 1:
Line-up the RF10 with the other
remote control, head-to-head,
one or two inches apart.
STEP 2:
Press and hold both the desired
Component button (in this case
TV) and the ENT (Enter) button
for approximately 3 seconds.
The display on the LCD screen
will show LEARN, signaling that
you are now in LEARN mode and
ready to ‘teach’ your RF10.
IMPORTANT:You now have 30 seconds to
perform the next step while you are in
SETUP mode. If you don’t press a button
within 30 seconds, SETUP will disappear
from the screen, signaling that you have
exited LEARN mode and you will need to
start over.
STEP 3:
Press any button on the RF10
that you want to teach a com-
mand to. Once you press a but-
ton, the top of the screen display
will change from “LEARN” to
“READY”.
NOTE REGARDING SHIFT
FUNCTIONS: You can teach a
second additional command to a
button by pressing the SHIFT button,
then pressing the button you want
to teach. Additionally, using the
SHIFT button, you may teach
commands to the COMPONENT
buttons themselves at the AUDIO
mode. Simply select the AUDIO
component in STEP 2, press SHIFT,
and then the component buttons
you want to teach.
STEP 4:
Press and hold the button on the
other remote control that you
want to ‘teach’ to the RF10 until
the LCD display on the RF10
changes to either “GOOD” or
“FAIL”. It will then change to
“READY”. If the “GOOD” label
appears on top of the display, you
were successful.
Now, continue to teach the RF10
any other commands from your
other remotes by repeating STEPS
3 and 4 until the RF10 has learned
all the buttons you want.
If the “FAIL” label appears on top
of the display, try ‘teaching’ the
same button to the RF10 once
again by repeating STEPS 3 and 4.
13 14
Learning Method
BASIC SETUP
BASIC SETUP
Learning Method