Filter
Top Products
19 20
Transmitting (Busy Signal) Icon
CUSTOMIZING
Customizing the LCD Touch Screen
CUSTOMIZING
STEP 1:
Press and hold the MAIN and
ENT (Enter) buttons at the same
time for approximately 3 seconds,
until the word “SETUP” is
displayed at the top of the LCD
touch screen. This signals that
you are now in setup mode.
STEP 3:
Press the TEXT button. The
screen will display the list of
Components and “EDIT” will
appear at the top of the screen.
STEP 4:
Navigate to the Component and
page where there is a button
label you want to EDIT, selecting
between the FAV, MAIN,
COMPONENT; then using the
PAGE button.
STEP 2:
Press the EDIT button. The LCD
display will change to the EDIT
menu.
IMPORTANT:You now have 30 seconds to
perform the next step while you are in
SETUP mode. If you don’t press a button
within 30 seconds, SETUP will disappear
from the screen, signaling that you have
exited setup mode and you will need to
start over.
NOTE: If you wish to change the name of
a Component button, press the Page (
)
button twice.The top of the display will
change to MAIN, and you can navigate to
MAIN page 1 or page 2 before going on
to Step 5.
When a command is being transmitted, an icon will appear
in the upper right corner of the LCD screen. This indicates
that a signal is being sent. This is particularly useful when
setting up Macros and FAVs, since it flashes with every step
of a sequence of commands.
Transmitting (Busy Signal) Icon
After you’ve finished all your basic setup, you can choose
to make operation easier by customizing the RF30 just the
way you want, using the Special Advanced Setup Features
described in this section.
Customizing Your RF30 with Special
Advanced Features
You can easily edit or change the name of any of the
display buttons (including Favorite Channels) on the LCD
screen by following these steps:
Customizing the LCD Touch Screen
CHILD LOCK FEATURE
This ‘child-lock’ feature prevents the unauthorized use of
the remote control by children. It blocks all operations of
the remote control.
To Activate:
Press the +10 and ENT (Enter) buttons simultaneously for
3 seconds. The bottom of the LCD will blink “LOCKED” three
times and then display “LOCKED”.
To Return to Normal Operation:
Press the +10 and ENT (Enter) buttons simultaneously again
for 3 seconds. The LCD will display the last use mode.