Filter
Top Products
12
Pre-Programmed Code Method
BASIC SETUP
11
Pre-Programmed Code Method
BASIC SETUP
STEP 7:
Point the RF30 toward the
Component you want to
program, (in this example, TV),
and punch in the 3-digit code
that you wrote down for that
specific Component. Use the
Number buttons 0-9 on the
remote to punch in the code.
If the 3-digit code number that
you just punched in is correct,
the Component will turn off. If
the Component does not turn
off, continue entering code
numbers from your list until the
Component turns off. Some
brands have several possible
code numbers.
STEP 8:
When the Component turns off,
press the ON button to turn the
Component back on. Now you
can test the Volume and
Channel buttons (for TV), or
PLAY and STOP (for VCR and
DVD) to make sure they all
work. If any of the buttons do
not work properly, you need to
find a new correct code. For
example, maybe your Sony TV
turned off with code number 147,
but the volume controls did not
work properly. If this is the case,
try the next code number listed
for that Component until you find
a perfect match.
ON
BUTTON
VOLUME
BUTTONS
CHANNEL
BUTTONS
PLAY
BUTTON
STOP
BUTTON
UP & DOWN
BUTTONS
NUMBER
BUTTONS
NOTE:
If the Component fails to turn off after you have entered
all the code numbers listed for your brand, you can scan
through all the other code numbers that are pre-loaded
into the RF30 for that Component (in this case TV) by
using the UP or DOWN buttons on the screen. (There is
a chance that your Component was actually manufactured
by another brand.) However, most of the code tables are
so large that it is usually faster to use the Learning Method
on Page 15.