Filter
Top Products
25 26
Favorite Channel Setup
CUSTOMIZING
MacroPower Setup
CUSTOMIZING
SAVE
BUTTON
MacroPower
TM
Setup
MacroPower
TM
is a unique feature that enables you to turn
all of your Components ON or OFF, at the same time, simply
with the press of one button. We call that a “Macro”.
What would normally take multiple remotes and button
pushes, the RF30 can accomplish with the press of one
button. In addition to the Power ON or OFF buttons, any of
the Display buttons (on any Component or Page) can be set
to be Macro buttons as well. Feel the power!
To setup a Power ON macro button that will turn ON several
components at the same time (for example, TV, VCR and
CABLE), follow these easy steps:
STEP 7:
Press the LIGHT button after you
enter the channel number. A
new screen appears displaying
SAVE, UNDO or EXIT.
STEP 8:
To save the channel you
entered, press the SAVE button.
The UNDO button lets you erase
the last entry. The EXIT button
erases all entries for this button.
STEP 9:
When you are finished setting
up Favorite Channel buttons,
press the MAIN button twice to
return to normal operation.
STEP 1:
Press and hold the MAIN and
ENT (Enter) buttons at the same
time for approximately 3
seconds, until the word “SETUP”
is displayed at the top of the LCD
touch screen. This signals that
you are now in setup mode.
STEP 2:
Press the MACRO button on the
LCD screen. The top of the
screen will display “MACRO”.
The bottom of the display will
flash “SELECT”.
STEP 3:
Press the ON button. “ON” will
display at the top of the LCD
screen. “STEP0” will display at
the bottom of the screen
indicating that no macro steps
have been entered yet.
STEP 4:
Press the first component
button you want the Macro to
turn on (in this example, TV)
and “TV” will display at the top
of the screen and “STEP 1” at
the bottom.
STEP 5:
Then, press the ON button to
confirm the command and
“STEP 2” will display at the
bottom of the screen. (NOTE:
Whenever a button is pressed,
another Macro step is counted
and displayed at the bottom of
the screen.)
STEP 6:
Now, press the MAIN button to
return to the Main Component
listing. (“STEP 3” will display at
the bottom of the screen.)
IMPORTANT:You now have 30 seconds to
perform the next step while you are in
SETUP mode. If you don’t press a button
within 30 seconds, SETUP will disappear
from the screen, signaling that you have
exited setup mode and you will need to
start over.