Filter
Top Products
15 16
Learning Method
BASIC SETUP
Learning Method
BASIC SETUP
MAIN
BUTTON
ENTER
BUTTON
LEARN
BUTTON
STEP 1:
Line-up the RF30 with the other
remote control, head-to-head,
one or two inches apart.
STEP 2:
On the RF30, press and hold the
MAIN and ENT (Enter) buttons
at the same time for approxi-
mately three seconds, until the
word “SETUP” is displayed at
the top of the LCD touch screen.
This signals you are now in
SETUP mode.
STEP 3:
Press the LEARN button on the
LCD screen. The top of the
screen will change to “LEARN”
and display the seven
Components (and FAV) from
Page 1 of the MAIN menu.
To display Page 2 of the MAIN
menu that lists an additional
eight Components, simply press
the ( or ) Page buttons at the
bottom of the screen.
STEP 4:
Select the Component you want
to teach commands to by
pressing that Component button
on the LCD screen (in this
example, TV). The top of the
screen will change to “TV”.
IMPORTANT:
You now have 30 seconds to perform
the next step while you are in SETUP
mode. If you don’t press a button
within 30 seconds, SETUP will disap-
pear from the screen, signaling that
you have exited setup mode and you
will need to start over.
NOTE: If you want to teach any com-
mand to a Component button, press the
Component button once the top of the
screen displays “MAIN”, by pressing the
PAGE button. The top of the screen will
change to "READY". Then go to STEP 6.
The RF30 can actually ‘learn’ commands from other remote
controls (old or new), one-button-at-a-time, so it will never
become obsolete. RF30 is the last remote you’ll ever need!
Just follow these simple steps:
Learning Method