Filter
Top Products
Global Settings
ETV Portal Server Admin Guide 37
3. In Select VBrick, select one or more existing VBricks for which a SAP has been received.
If you select one VBrick, this populates the VBrick Configuration panel. (If you select
multiple VBricks, it does not populate the panel; if you need to configure the VBricks,
you must add them one at a time.)
4. Complete or modify the fields in
VBrick Configuration as necessary. Note that you must
enter a User Name and Password and confirm that Password or the configuration will
fail.
5. Click
Submit when done. This adds the new configuration to the list of configured
VBricks shown on the previous page.
Note The only time you will manually complete the VBrick Configuration fields is when
you are defining the configuration for a VBrick that will be added to the network at a
later time. In this case, you will need to know the following configuration data in
advance.
Host Name Required. Host name of VBrick.
IP Address Required. IP address of VBrick.
User Name Defaults to system-defined value if blank.
User Password Defaults to system-defined value if blank.
Confirm Password Defaults to system-defined value if blank. Must match User Password
if entered above.
Software Revision Optional. To get the Software Revision in IWS, go to
Status >
System Information >
Release Revision.
HTTP Port Optional. To get the HTTP Port in IWS, go to
Configuration >
System > Security > IWS Server Port
.