Filter
Top Products
Installation
50 Vision Model 140/150 Installation/Operation Manual
PRE
L
IMINAR
Y
3. Select Locked from the Channel Setup menu and press ENTER to clear the check box.
Figure 3-19. Unlocking a Channel
Auto Setup Use the Auto Setup feature of the Vision 140/150 as a convenient starting point for
calibrating the projector DVI input for optimum picture quality.
Auto Setup is an automated process in which the projector quickly optimizes critical display
parameters such as size, position and pixel tracking, based on the type of incoming video
signal. An Auto Setup allows you to quickly get the image “in the ballpark” after which you
can perform further calibration, if necessary.
To perform an Auto Setup, do one of the following:
On the Theater Master Remote Control: Press FUNCS, then AUTO followed by Enter.
When the Auto Setup completes, press Enter again to keep the new settings.
On the Projector Rear Keypad: Press AUTO SETUP followed by Enter. When the Auto
Setup completes, press Enter again to keep the new settings.
On the VHD Controller Remote Control: Press MENU, then select Service from the Main
menu. Select Display Device from the Service Menu. Finally, select Configure from the
Display Device menu, then select Auto Setup.
What an “Auto Setup” Does: Auto Setup sets the following parameters to their default
values:
• White Level (Contrast)
• Black Level (Brightness)
• Pre-Calibration (Auto Input Level) (off)
• Sharpness (Detail) (if video source)
•Filter
•Luma Delay
1. Name 16x9 night
2. Number 02
3. Input 2
4. In Menu
5. Auto Source
6. Locked
7. Previous Channel
8. Next Channel
Sync Type: Digital Encrypted
H-Sync: 26.97 kHz
V-Sync: 23.98 Hz
Interlace: No
Channel Edit
Clear this check box to unlock the channel
➤
You cannot use Auto Setup with a locked channel; you must unlock it
first. Refer to
Unlocking Channels on page 49.
Note