Filter
Top Products
11
5. DIGITAL VIDEO RECORDER ACTIVATION AND TERMINATION
5.1. Recorder's Activation
1. Insert the power supply plug.
The Recorder is placed in standby mode. The power
key flashes at about 5-second intervals while in standby
mode.
Note
Do not pull out the power supply plug while the Power
key is light green. Ensure that the Recorder is in the
standby mode when pulling out the power supply plug.
Logged data could be damaged or lost if the power
supply plug is pulled out during initialization (while
accessing the hard disk).
2. Press the Power key while the Recorder is in standby mode.
The Power key flashes green during a system check. The Power key changes from flashing to steady ON
after system check completion, allowing camera images to be displayed.
5.2. Recorder's Power Off and Disconnect
Hold down the Power key for 2 seconds or more. All operations stop, placing the Recorder in standby mode.
When moving the Recorder, be sure to place it in standby mode, then remove the power supply plug from the
wall outlet.
Power key LED indicator
Mode
Distinguishes Main power OFF
Flashes (5sec)
Standby mode
Lights
Power ON (during operation)
Flashes (1sec)
During a system check
(during activation)
MAIN MENU
REC SETTING
DISPLAY SETTING
NETWORK SETTING
MAIL SETTING
SYSTEM SETTING
LOG DISPLAY
DATE/TIME SETTING
MAINTENANCE
IMAGE ARCHIVING
6. MAIN MENU SETTING
6.1. About the Main Menu Settings
To perform each setting, display the Menu screen when in live mode.
1. Holding down the Menu key for 2 seconds or more.
Displays the Menu screen.
Notes
• Menu screen is not displayed while the Monitor Output 2 is
selected. (while the Monitor key is lit).
• Display the Menu screen after returning to the live mode when
in playback mode.
• Menu screen is not displayed while in zoom mode and during
zoom display (while zoom key is lit)
2. To move the cursor, use the [ ] and [ ] keys.
The [ ] and [ ] keys can be used to move the cursor only when there are setting parameters.
3. To select or change parameters, use the [+] and [–] keys.
4. Press the Menu key at the mark at the desired setting item.
If no change has been made to the current parameter:
The screen moves to the next screen.
If changes have been made:
Save setting confirmation message is displayed. (Refer to the next page.)
5. To exit the setting and return to the previous screen, press the [ ] key at the leftmost parameter position
of the screen.
A Save Setting confirmation dialog is displayed if changes have been made. If set value has not been
changed, the screen moves to the previous screen, Exits the Menu screen when the Main Menu screen is
displayed.