Filter
Top Products
VIZIO M261VP User Manual
Version 6/15/2010 55
www.VIZIO.com
M261VP Specifications
Dimensions 25.24” W x 17.95” H x 6.68” D with stand; 25.24” W x 15.90” H x 1.34” D without stand
641 x 456 x 169.7 mm with stand; 641 x 403.8 x 34 mm without stand
Net Weight 10.14 lbs with stand; 9.7 lbs without stand
4.6 kg with stand; 4.4 kg without stand
Gross Weight 16.98 lbs; 7.7 kg
Certifications CSA, CSA-US, FCC Class B
Compliances Energy Star 4.1. ATSC Spec A/65, EIA/CEA-766-A
Compliance
Caution: Always use a power cable that is properly grounded. Use the AC cords listed below for each
area.
USA: UL Canada: CSA
Germany: VDE UK: BASE/BS
Japan: Electric Appliance Control Act
FCC Class B Radio Interference Statement
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses, and can radiate radio
frequency energy, and if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
4. Consult the dealer or an experienced radio/TV technician for help.
Notice:
1. The changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
2. Shielded interface cables and AC AC/DC power adapter, if any, must be used in order to comply with
the emission limits.
3. The manufacturer is not responsible for any radio or TV interference caused by unauthorized
modification to this equipment. It is the responsibilities of the user to correct such interference.